faqs

The saw is not cutting;

Check the engine power and speed(rpm).
Make sure the saw is unbinded; if not work the saw after using a soft abrasive on the surface of the saw.
Check the fitting and compabıility of the saw and the machine/machine slot.

Too much jolting/kickback during cutting;

Make sure that the material that is being cut is fixed firmly to the workbench.
Make sure the saw is unbinded; if not work the saw after using a soft abrasive on the surface of the saw.
Check the fit of the saw radius and the flange radius, and make sure that they are compatible.
Check the main shaft.
If jolting is present in both ways of revolution, decrease the tension on the saw.
Check the compability between the saw and the material-to-be-cut.

When feedrate is increased, the current gets too high;

Control linear speed.
Check the accordance of engine power and saw radius.
Check cutting speed.
Decrease cutting depth.
Make sure the saw is unbinded; if not work the saw after using a soft abrasive on the surface of the saw.

Lifespan of the saw is too short;

The saw's segments may be too soft for the material that is cut; change the saw accordingly.
Cooling may be inefficient. Check the amount of cooling water.
Cooling water may be contaminated wıth dirt or chips or granule; check the water.
The saw may be experiencing extreme jolting.
Engine power and rpm may be too high.

There is fracture on the saw;

If there is a fracture on the body of the saw, drill a 5mm radius hole at the end of the fracture.
If there are multiple fractures on the body of the saw, control the saw tension.

The segments get cracked;

The saw is not compatible with the material. Change the saw with an appropriate one.

The segments are overworn in both sides;

Check the tension on the saw.
The segments on the saw may be too short to do the needed cuts. Use an appropriate saw model.

Diamond Saw Segments are overworn in both sides;

Check the tension on the saw.
The segments on the saw may be too short to do the needed cuts. Use an appropriate saw model.

Diamond Saw Segments have abrasion in its middle part;

Diamond Saw Segments have abrasion on one side only;

Due to mechanical issues on the machine tools, there may be a problem on the saw rotation.
Perform the horizontal stability control of the saw.
Make sure that cooling water reaches both sides of the saw equally.
Check whether both sides of the flange are equal.
Check the tension on the saw.

The segments and cam are overworn;

There is jolting on the saw, and the tension vanishes;

There may be friction between the saw body and the subject stone.
The saw body may be overheating; check the cooling water.
Control the flanges.
The diamond segments may be too hard for the subject stone; check compatibility.
There may be a problem wıth the power engine and rpm. Arrange accordingly.